1. Choose model
XSM/XTM 125 (ab 2019)
2. Filter by category
No results were found for the filter!
Oil contamination on the underbody or on the engine is due to a defective seal. In many cases the valve cover gasket is the cause. When servicing the valve train, it is often not replaced. In general, seals should always be replaced to...
Available
€53.95
*
Replacement fuel injector from Piaggio. Suitable for 125cc 4-T Aprilia engines. OEM part number for comparison 890225
Almost gone
€139.90
*
Hose clamp, universal, 8 x 300mm
Practical set for assembling hose clamps yourself. Consisting of 8 screw clips and a 30cm long steel band. The band can be torn off in the desired length, then only the clip is attached and the clamp is ready for use. Notes Cut the tape...
Available
€5.99
*
Copper seal ring. Technical data Inner diameter: 31.50 mm Outside diameter: 40.00 mm thickness: 4 .00 mm
Available
€5.95
*
Replacement graphite manifold gasket. Fits in principle all vehicles with straight flange or plug-in flange connections up to 42mm diameter. (42mm is for example the original size of the Yamaha YI-3 & YI-4 engine).
Available
€4.99
*
Aluminium/steel manifold gasket from Athena. Can be used on all vehicles with the corresponding outlet dimension of 45mm diameter.
Available
€4.50
*
Fuel tap, universal, M16 x 1,5
Largely universal, vacuum-controlled petrol tap with screw connection. The scope of delivery also includes the pre-filter (tube), which sits in the petrol tap. Suitable for all petrol tanks with corresponding thread & vacuum connection....
Available
€10.99
*
The timing chain tensioner is an important component. In the event of a defect, it can even lead to engine damage. Due to the pressure that the tensioner puts on the timing chain, it is always optimally tensioned. If this is not the...
Out of Stock
€20.95
*
Paper seal to seal the timing chain housing. Should be replaced during all maintenance work on the timing chain tensioner. OEM part number for comparison purposes 430350; 834254; 862777; AP8550429; AP8575011; 847928
Available
€3.19
*
A rattling noise from the engine can often be explained by a worn timing chain. Poor oil or few oil changes will damage the timing chain. In addition, a defective timing chain tensioner can lead to problems with the chain. In order to...
Out of Stock
€99.90
*
;
€69.95
*
Graphite sealing ring from Athena. Can be used in many different vehicles as a seal for overlapping plug connections.
Almost gone
€13.95
*
Hose clamp assortment, 50 parts
Galvanized steel hose clamps with worm thread for attaching hoses to pipes and hose nozzles. Including 8mm socket wrench. Sizes: 12 x 13-19mm 12 x 16-22mm 10 x 18-27mm 7 x 20-32mm 5 x 22-38mm 3 x 24-44mm
Available
€27.95
*
18mm hose clamp from Piaggio, can of course be used on all vehicles. OEM part number for comparison purposes 879888; 256074; 577557; AP8104072
Available
€4.99
*
Available
€1.99
*
Spare gasket for the ignition cover.
Out of Stock
€4.99
*
Available
€1.49
*
Copper seal ring. Inner diameter : 26,2 mm Outside diameter : 35 mm Thickness : 1,5 mm
Available
€3.99
*
Spare gasket for the clutch cover of the Aprilia RS4 125 or all mopeds with Piaggio 125cc 4-T engine.
Available
€11.99
*
A well sealed motor is a basic prerequisite for proper functioning of the drive. A loss of oil can lead to gear damage or malfunction of the entire drive. Note: Illustration deviates!
Out of Stock
€19.99
*
Oil hose, universal
In the course of time the original hose can become porous, so that oil leaks out. This will not only make your engine dirty, but it will also lose lubrication, which can lead to the dreaded piston jam. 1m - universally applicable. 3 x 5mm
Available
€2.99
*
Petrol tap, universal
Manual fuel tap. Especially useful for converted carburettors or intake manifolds which are not equipped with a vacuum connection. Usually the vacuum taps are then drilled through. In order to prevent the unintentional leakage of petrol...
Almost gone
€8.49
*
Spring clip for fuel line
Spring clip for a tight fit of the fuel hose on the fuel tap and carburetor connection. 8,8 - 9,5mm
Available
€2.99
*
If you don't want to change the thermometer in the cylinder head, or the thread doesn't fit, we can offer you this nice anodized adapter which is simply put between the cooling hose. Fits in combination with Stage6 Multimeter & Koso PRO...
Available
€28.95
*
Viewed