1. Choose model
Duke 125 (ab 2024, IS DK A (Euro 5+))
Duke 125 (2021 bis 2023, IS DUKE - Euro5)
Duke 125 (2017 bis 2020, IS DUKE - Euro4)
Duke 125 (2011 bis 2016, Euro3)
2. Filter by category
No results were found for the filter!
This item is an original spare part from the KTM brand. OEM part number for comparison purposes: 90135053000
Almost gone
€9.99
*
This item is a original spare part (OEM) of the brand KTM. OEM part numbers for comparison purposes KTM 93032060000 Scope of delivery: 1 pc.
Out of Stock
€44.95
*
Experience has shown that the water pump sealing rings are a weak point in motorcycle engines. As soon as the oil in the gearbox takes on a milky, dull colour, you should check whether the Simmerrings of the water pump are still properly...
Out of Stock
€25.95
*
If it rattles or clatters in the engine, especially when it is cold, the timing chain is usually worn. The timing chain tensioner is usually automatically operated in modern 4-stroke engines. If this is also already at the stop, the...
Available
€57.95
*
This item is an original spare part (OEM) of the brand KTM. OEM part number for comparison purposes 90136003000 Scope of delivery: 1 pc.
Available
€64.95
*
This item is an original spare part (OEM) of the brand KTM. OEM part number for comparison purposes 93530040000 Scope of delivery: 1 pc.
Almost gone
€14.90
*
The coolant thermostat is an important part of the cooling system. If it no longer opens or closes correctly, the engine can overheat or undercool while driving. In the worst case, this can lead to engine damage. Therefore, you should...
Available
€31.95
*
This article is an original spare part (OEM) of the brand KTM OEM part number for comparison purposes 93530027000 Scope of delivery: 1 pc.
Available
€12.99
*
This article is an original spare part (OEM) of the manufacturer of the brand KTM.
Available
€2.19
*
This item is an original spare part (OEM) of the brand KTM. OEM part numbers for comparison purposes - KTM 90136003003 Scope of delivery: 1 pc.
Available
€2.99
*
This article is an original spare part (OEM) of the manufacturer of the brand KTM.
Out of Stock
€2.99
*
Arrow replacement seal. Can be used not only with Arrow, but also with all other exhaust systems with 32mm diameter and plug-in flange. Technical data Diameter (inside): 32mm width: 30mm
Available
€10.00
*
Clamps / hose clamps, 50 parts
Practical assortment box with different sizes of hose clamps. Should not be missing in any well-assorted workshop. Delivered are 10 clamps each in 6, 8, 10, 12 and 14mm diameter.
Available
€34.95
*
Reinforced clutch springs increase the contact pressure on the clutch linings and thus prevent the clutch from slipping. Especially after tuning work. Reinforced clutch springs can be used as a spare part for lighter tuning stages but...
Out of Stock
€14.99
*
Reinforced clutch springs from EBC, 10% harder than the original springs. Provides relief for slipping clutches by increasing performance.
Almost gone
€15.50
*
Hose clamp, universal, 8 x 300mm
Practical set for assembling hose clamps yourself. Consisting of 8 screw clips and a 30cm long steel band. The band can be torn off in the desired length, then only the clip is attached and the clamp is ready for use. Notes Cut the tape...
Available
€5.99
*
Replacement seal from Athena. In case of oil leaks or adjustment work on the open cylinder head, gaskets should be replaced as a precaution.
Almost gone
€22.95
*
Replacement rubber from Athena. In case of oil leaks, or adjustment work on the open cylinder head gaskets should be replaced as a precaution. This rubber seals screw holes. Delivery 1 piece.
Available
€3.99
*
Copper seal ring. Technical data Inner diameter: 31.50 mm Outside diameter: 40.00 mm thickness: 4 .00 mm
Available
€5.95
*
Replacement graphite manifold gasket. Fits in principle all vehicles with straight flange or plug-in flange connections up to 42mm diameter. (42mm is for example the original size of the Yamaha YI-3 & YI-4 engine).
Available
€4.99
*
Aluminium/steel manifold gasket from Athena. Can be used on all vehicles with the corresponding outlet dimension of 45mm diameter.
Available
€4.50
*
Maintenance work on the engine is always a good opportunity to replace the seals at the same time. If maintenance work is necessary on the alternator side of the engine, we recommend to install a new gasket, if the cover is already removed.
Out of Stock
€8.99
*
If the coupling is replaced or other maintenance work is pending under the coupling cover, it is always advisable to invest in a new seal at the same time. Subsequent oil leaks are always annoying and can thus be avoided.
Almost gone
€7.99
*
Complete engine gasket set from Athena, suitable for KTM 125cc 200cc and 390cc 4-T engines. The gasket set includes cylinder base, head & valve cover gaskets as well as the gaskets for clutch & alternator covers and many other small...
Out of Stock
€76.95
*
Viewed