No results were found for the filter!
Fuel tap Original spare part OEM part number for comparison purposes AP8102819
Available
€29.99
*
Exhaust slider, Rotax 122/123 (Aprilia RS/RX/SX 125, 2-stroke), adjustable
The exhaust slide valve of throttled Rotax 122 & 123 engines is opened abruptly at 8,000 rpm by the electrical control of the slide valve. Not everyone can cope with this sudden power delivery and not everyone wants to be driving at such...
Available
€169.90
*
;
€129.90
*
Pneumatic exhaust system for the Aprilia RS 125 engine. Most people will have noticed on their 125cc Aprilia RS that when the engine is de-throttled the power is suddenly released at around 8000 rpm by opening the exhaust slide. As this...
Almost gone
€155.90
*
This wiring harness is needed to connect the Polini ECU device to Yamaha injectors.
Out of Stock
€24.95
*
The Malossi Force Master II system primarily manipulates the injection times, which are passed on from the original control unit to the injection nozzle. This system is included in the 180cc cylinder kit. With three different...
Almost gone
€285.00
*
With the Athena GET Chiptuning, the original performance of the KTM Duke can be increased by a few extra horsepower, depending on which setup is used. The GET unit is simply exchanged for the original CDI control unit. Afterwards the...
Almost gone
€329.95
*
The V-Force reed valve block from Italkit has a maximum cross-section on the smallest valves. This allows the diaphragms to open and close with less inherent gas force, resulting in higher efficiency and improved motor performance....
Almost gone
€109.90
*
Replacement petrol tap for Rieju motorcycles (MRT). Technical data Diameter: 15mm Cock positions : Left side : To Top : Open Right : Reserve Incl. fuel filter. OEM number for comparison : 0/000.370.0500
Available
€12.99
*
Here we offer a vacuum fuel tap for all motorcycle models with carburetor. The fuel tap is simply pushed into the tank instead of the old one and can also be used to convert from manual operation to automatic operation. We recommend to...
Available
€8.99
*
Here we offer a simple choke, with an actuator, which can be installed in the fairing of the vehicle as desired. The lever is delivered with a cable pull, can only be used in vehicles with carburetor.
Available
€12.99
*
6mm clamp for fuel hoses. Delivered is 1 piece.
Available
€1.99
*
Fuel hose with one meter length and 5mm inner diameter. In many different colours. In addition to its actual use as a petrol hose, it can also be used as a hose for many other purposes. Available in many different colours. The hose can...
Available
€2.00
*
NEW
Manual choke cable Motoforce, PWK / CP / Flat Slide carburetor, red
The manual choke for PWK and Polini CP carburetors gives you full control over the cold start of your scooter or moped. Instead of relying on an automatic choke, you can now adjust the fuel/air mixture manually. This ensures reliable...
Available
€6.90
*
Fuel hose / petrol hose, 1m, neoprene, rubber compound, various diameters
Fuel hose / Petrol hose In the following variants: 6mm 7mm 8mm Length : 1m
Available
From €14.99
*
Fuel filter, 7mm, various colors
The aluminum elements of this fuel filter are available in different colors. This allows the filter and hoses to be visually matched. The connection width of the filter is 7 mm. The fuel hoses we offer are therefore a perfect fit.
Available
€9.99
*
Float chamber drain plug, PWK Carburetor, Orange
Simple styling part for flat slide and type PWK carburetor. The screw is made of anodized aluminum. Delivery Incl. gasket
Available
€6.00
*
Oil hose, 2,2x4mm, 5m long, green, universal
Here we offer you a transparent green oil hose. Dimensions: Inner diameter: 2,2mm Outer diameter: 4mm Length: 5m
Available
€3.49
*
Oil hose, 2,5x5mm, 5m long, green, universal
Here we offer you a transparent green oil hose. Dimensions: Inner diameter: 2,5mm Outer diameter: 5mm Length: 5m
Available
€3.99
*
choke lever, Universal, various colors, for mounting on handlebars
Universal choke lever for custom conversions. Simple mounting with clamp, directly on the handlebars as mentioned, fits virtually any cable choke. Available in black & chrome.
Available
€10.99
*
Carburettor DellOrto PHBH 28 BS, universal
The PHBH 28mm version can be used as a replacement carburettor on various 125cc vehicles (e.g. RS 125). On 125s with a smaller carburettor, it can even have a slight performance-enhancing effect if tuned correctly. Note Does NOT have an...
Out of Stock
€139.90
*
Fuel tap, universal, M16 x 1,5
Largely universal, vacuum-controlled petrol tap with screw connection. The scope of delivery also includes the pre-filter (tube), which sits in the petrol tap. Suitable for all petrol tanks with corresponding thread & vacuum connection....
Available
€10.99
*
Carburetor Racing PWK34, Incl. Powerjet
The recessed intake tract ensures better airflow and thus improved engine response. The outer dimensions of the carburettor as well as the intake manifold connection width (up to 30mm: 35mm/ from 32mm: 40mm) have been reduced for easier...
Available
€79.95
*
Oil hose, universal
In the course of time the original hose can become porous, so that oil leaks out. This will not only make your engine dirty, but it will also lose lubrication, which can lead to the dreaded piston jam. 1m - universally applicable. 3 x 5mm
Available
€2.99
*
Petrol tap, universal
Manual fuel tap. Especially useful for converted carburettors or intake manifolds which are not equipped with a vacuum connection. Usually the vacuum taps are then drilled through. In order to prevent the unintentional leakage of petrol...
Almost gone
€8.49
*
Du bist auf der Suche nach hochwertigen Ersatzteilen oder Tuningkomponenten für dein 125er Motorrad? Dann bist du bei uns genau richtig! Als Experten für ansaug- und Einspritzsysteme bieten wir alles, was du für eine Reparatur oder Optimierung deines Bikes brauchst.
Ob du nun auf der Suche nach einem neuen Luftfilter, Vergaser oder sogar einem kompletten Einspritzsystem bist – bei uns wirst du garantiert fündig. Und das Beste daran: Unsere Produkte sind nicht nur von bester Qualität, sondern auch noch zu erschwinglichen Preisen.
Egal, ob du ein erfahrener Tuner bist oder gerade erst damit beginnst, dein Bike aufzumotzen: Mit unserem breiten Angebot an ansaug- und Einspritzsystemen bist du für jede Situation gerüstet. Auch wenn du dein Bike einfach nur mit hochwertigen Ersatzteilen auf Vordermann bringen möchtest, sind wir die richtige Adresse für dich. Also worauf wartest du noch? Schau jetzt bei uns vorbei und sichere dir alles, was du für dein 125er Motorrad brauchst! Wir freuen uns auf dich!
Viewed