To be able to use Radical Racing in full range, we recommend activating Javascript in your browser.

Manufacturer: Presto
Order number: 443381
2004513400003

Presto plastic filler 250g, black

Available

Order within the next 13 hours and 46 minutes so the order is shipped tomorrow .

€6.99 *

Content: 0.25 Kilogramm (€27.96 * / 1 Kilogramm)

Prices incl. VAT plus shipping costs

Seen cheaper?

Plastic filler "styrene-free" from Presto is a two-component, black polyester filler. Suitable for filling scratches and damage and for refinishing bonded plastic parts.

Its thixotropy and smoothness make it easy to restore contours and profiles. The filler adheres to all plastics commonly used on vehicles, such as PP, PUR, ABS, PA, PVC.

In addition to its very good adhesion to almost all plastics, the filler can also be applied to body panels and galvanized sheets.

QUALITY AND PROPERTIES

Easy processing
High elasticity
Easy to sand
Very good adhesion
Free of asbestos and silicone
Non-porous
Resistant to weak acids, weak alkalis, blowing agents, solvents, water and de-icing salts

PHYSICAL AND CHEMICAL DATA

Basis: Polyester resin with mineral fillers
Color: black
Odor: characteristic
Form: pasty, soft, thixotropic
Pot life/processing time at 20°C: approx. 7 - 8 min.
Working temperature: from 12°C
Drying (at 20°C, 50% relative humidity):
Sandable after: approx. 30 - 40 min
Flash point:
approx. 33°C (filler); not applicable for hardener
Density at 20°C:
filler 1.85 g/cm³
hardener 1.15 g/cm³
Addition of hardener: 2 - 4 % (optimum mixture 2.5 %)
Temperature resistance of cured material: 120°C
Shelf life/storage:
18 months when stored properly (=10°C - 25°C, relative humidity of max. 60%) in closed original container. Protect from direct sunlight, frost and moisture.
Packaging:
putties: narrow ring tins, 250 g
hardener: plastic tubes

ENVIRONMENT AND LABELING

Environmentally friendly: European Aerosols strives to use formulations without regulated or questionable ingredients, while maintaining the best possible performance. Caps and packaging are made from recyclable materials.

Disposal: Please recycle only empty containers. Take containers with residues to the problem waste site.
Only for DE: In order to ensure a high reuse and recycling rate, the legislator requires, in accordance with §15 - VerpackG, Paragraph 1, that transport, sales or outer packaging be taken back; alternatively, however, deviating agreements can also be made.

INSTRUCTIONS FOR USE

Always read and observe the caution texts carefully before use!

Application

The surface to be filled should be derusted, clean, dry, free of grease and sanded.
Take the required quantity of material from the package and mix well with the corresponding quantity of hardener.
Apply the mixed material in the desired layer thickness.
After approx. 30-40 minutes, the filled surface can be drilled, sanded, sawed and painted.
Clean tools immediately after use, wash off with nitro thinner if necessary.
Do not return remnants of mixed material to the can.
The filler adheres to all plastics commonly used on vehicles, such as PP, PUR, ABS, PA, PVC.
Not suitable for soft plastics!